Can I Get Glass With a 45 Degree Edge
Edge Finishes
Swiped Edge: Lightly Abraded (** Automotive border No. 4)
Seamed Edge: Abraded heavier than a swiped edge.(** Automotive Edge No. three)
Arrissed Edge: Small bevel of width not exceeding 1/16″ at an angle of approximately 45° to the surface of drinking glass.
Flat Edge: Cut edge of glass is flat and surface edges have aris edges.
Pencil Edge: (also known as round, weber, crown, semi-round, half-moon, diamond) Cutting border of glass slightly curved to course an arc of a circle of selected radius. Degree of roundness depends on mechanism used. (** Automotive edge No. ane – Limited to small shiners or wheel skips, ** Automotive edge No. 2 – Larger shiners permissible)
Bevel Edge: Surface edge of glass beveled to ane/8″ or more in width as required. Angle formed by intersection of the plane of the bevel with the face of glass is 3° to 10°. Nose of bevel left as cutting unless finish is specified.
Miter Bevel: Cut border of drinking glass beveled to an angle of approximately 45° (unless otherwise specified); the knife-edge indicate is slightly arrissed. If required, the knife-edge can have a slight radius to course an arc of a circle when in contact with respective edge of some other plate.
Definitions of the surfaces for edge finishes used above are every bit follows:
- Ground surface exhibits fine linear and random abrasion marks, crude in advent.
- SMOOTHED surface with a frosted appearance which defuses and reflected lite.
- POLISHED surface is reflective in appearance similar to the major surface of drinking glass.
Source: http://www.cgcglass.com/edge-finishes/
0 Response to "Can I Get Glass With a 45 Degree Edge"
Post a Comment